this post is to test if i can easyly post pictures. here is a pic if my tool that dimples the annealed brass case of
my 50 cal S&W antique revolver. i did the same thing to some 38 SPL brass with known cup. I worked up a load
useing 225 grain heald full wadcutter bulets and copare the flattening of the dimples. better than nothing.
the triangle thing is my magnetic base brass trimmer that u just plunk on the drill press table , i used rare earth magnets
from lee valley. the cups to put the magnets in give the magnets 4 times the gripping force.
my 50 cal S&W antique revolver. i did the same thing to some 38 SPL brass with known cup. I worked up a load
useing 225 grain heald full wadcutter bulets and copare the flattening of the dimples. better than nothing.
the triangle thing is my magnetic base brass trimmer that u just plunk on the drill press table , i used rare earth magnets
from lee valley. the cups to put the magnets in give the magnets 4 times the gripping force.
