Coupling XCR 7.62 mags

[id64]

I have an idea for a XCR coupling. I've an extra for my 5.56 and decided to use one for them on XCR mag. Well, the problem is that bottom part of XCR mag is already angled and creating additional angle makes it completely weird. But if installed in revers then it looks great! The problem is that there are no tabs on the other end to hold them in place. Lets figure it out all together and have 7.62 Canadian 20

 

[blaxsun]

Are these the aluminium ones or polymer? (the aluminium ones have a hex bolt to keep them in-place)

 

[id64]

Are these the aluminium ones or polymer? (the aluminium ones have a hex bolt to keep them in-place)

Couplers? Polymer. Which aluminum are you referring to?

 

[Danimal247]

I have aluminum but no hex bolt on mine, was going to tape them

 

[blaxsun]

Couplers? Polymer. Which aluminum are you referring to?

Dlask sells an aluminium version which has a hex bolt that you tighten on one side to prevent the magazines from slipping off.

 

[id64]

I think I got it:

 

[blaxsun]

I think I got it:

That's ugly as sin, but hey - if it works...

 

[Shooter1of38]

I think I got it:

If you wanted to make a true 20 rounder Canadian edition, you should have used a Robertson headed screw!

 

[blaxsun]

If you wanted to make a true 20 rounder Canadian edition, you should have used a Robertson headed screw!

And a certain blue lubricant...