Crosman Mark I O-Rings

[tenringbound]

Just bought a nice Mark I and would like to change the O-rings, specifically around the piercing pin and the piercing body seal. Does anyone know where to get urethane rings to fit? Haven't been into airguns since I was a kid but am looking forward to taking it up again

 

[trevj]

Got a hydraulic shop around? Bearing and Seal supplier?

You can sort out the sizes pretty quick if you want to, and only replace what is needed, or you can talk to any of the Airgun suppliers and get a rebuild kit complete and do the whole works.

pabirdman, here on the Forum is worth shooting a PM to. D&L Airguns is even further West. There are a couple different airgun parts suppliers further East, as well.

Cheers
Trev

 

[tenringbound]

Thanks for the info Trev

 

[mbogo3]

http://my.tbaytel.net/coopers/CrosMkI/review.html#VelocityTests

 

[tenringbound]

Thanks to all who responded, got a complete seal kit from a fellow CGN'er and just installed them. Tight as a drum and shooting like new, beautiful gun