Custom Dies?

[350 Mag]

I recently acquired a 7 SAUM.

Want to get Lee to make Custom Collet neck sizing dies.

However, they require 2 fired brass from rifle and sample bullet.

Will I be able to ship these case to USA?

Anyone done this before?

 

[dogzilla]

Yes, as long as it isn't a loaded round.

 

[hunters home]

Yes, as long as it isn't a loaded round.

I've always wondered the same. Are you sure because we can't get brass sent the other way.

 

[back40sniper]

Will be no problem, mailed a "dummy" round to states for a custom reamer.

 

[dogzilla]

I've always wondered the same. Are you sure because we can't get brass sent the other way.

We can't get brass because of ITAR

 

[hunters home]

We can't get brass because of ITAR

Good to know TKS

 

[Ganderite]

I called them about a neck sizer for my 260Rem Ackley. They said a regular collet die would work. They were right.

Is there any other 7mm round that would have a standard collet die that would accommodate your case?

 

[350 Mag]

Ok great thanks.

 

[hart]

Buy a Lee 7mm WSM collet die and turn .132" off the bottom of the collet.
Can still be used with WSM by adding a .132" washer on top of the shell holder.

 

[350 Mag]

Buy a Lee 7mm WSM collet die and turn .132" off the bottom of the collet.
Can still be used with WSM by adding a .132" washer on top of the shell holder.

Thanx...