CZ 527 bolt handle scope clearence

[Canadian Bush Sniper]

At one point I had the old factory, new factory, and a glades armory bolt handle.

The action is a little prone to binding, I find the new style much better then the glades armory one was for smoothness.
Not as much off center pressure.

Warne medium fixed rings with a leupold 2-7x... I just couldn't find the QD rings at the time.

How was your cheek weld?. Did you have to raise your face abit to see the crosshairs or was it perfect?.

 

[conor_90]

Shockingly different people fit stocks differently

Cheek risers and rings of various heights can resolve any issues you may or may not have. Wait until you get the rifle and you will see if there is even a problem.

 

[Canadian Bush Sniper]

Shockingly different people fit stocks differently

Cheek risers and rings of various heights can resolve any issues you may or may not have. Wait until you get the rifle and you will see if there is even a problem.

Ahh k so wait till I get the rifle and see how it fits then get the Warne medium qd rings.

 

[Dorian Gray]

I ran Warne medium 1" rings on the 2 that I had. They worked fine.

 

[The Kurgan]

Ahh k so wait till I get the rifle and see how it fits then get the Warne medium qd rings.

Depending on the ocular, you may need high rings. Just wait until you shoulder it and then go for there. As I mentioned, medium Warne rings worked for me just fine with a smaller Japan-made Bushnell 3500 2-7x32.

 

[Canadian Bush Sniper]

Depending on the ocular, you may need high rings. Just wait until you shoulder it and then go for there. As I mentioned, medium Warne rings worked for me just fine with a smaller Japan-made Bushnell 3500 2-7x32.

I was thinking of a 4x12 or a 3x15 scope.

 

[Canadian Bush Sniper]

I was thinking of a 4x12 or a 3x15 scope.

Mean to say 3.5-14x40or42mm lense

 

[Pembykid]

Warne QD is the way to go for that. I have that set-up on my CZ557 Lux.

I do too on my 527 7.62x39… such a cool gun. Got a leupold VX-2 2-7 .. hard to QD it off