cz 858 FAB forestock fit issues?

the teardown (field strip)pin you pull by hand to remove the top forestock or hand guard. it apears there is interferance between the upper and lower FAB hand guard locator tabs, not allowing the top hand guard to be positioned rearward and down enough to insert the retaining (tear down) pin unless the lower hand guard is not fully installed
 
ok...trimmed some off the rear of the male locator tabs with a razor knife, then "shaved" the top surface of the lower hand guard(forestock) down just enough to assemble the top handguard on without too much force.....looks and feels nice cant wait to try it out!
 
You must log in or register to reply here.
Back
Top Bottom