CZ 858 Folding Stock Question

[Goonsquad]

I posted this in the FAQ section a couple of days ago with no hits, so here's a C&P of that post:

Quick question guys, I am quite happy with the factory arrangement on my rifle but am considering changing the buttstock to the CZ side folding unit sold by Wolverine. I was wondering if someone (who obviously has one installed) could measure the length of pull using the description below:

"The length of pull or LOP is measured from the forward face of the trigger to the end of the butt plate or butt pad. It should be measured to the point halfway between the heel (top) and the toe (bottom) of the butt plate."

The LOP is quite important for me and I would like to know if I have to get the folder adjusted prior to purchase.

Thanks for your help.

 

[Stevo]

LOP on the factory folder and the factory fixed stock are the same.

 

[Goonsquad]

Outstanding, thanks for your help.

 

[pie1]

LOP on the folder sold by vz58.net is longer. I am 6'5" and this was much needed. Factory fixed stock was much too short.

 

[Stevo]

Outstanding, thanks for your help.

I went and double checked it. Standing side by side there might be a fraction difference, thought that may be due to the slightly different shape of the two butt plates.

Here's a pic. They're not lined up perfectly, but you can see the pretty much identical LOP.

 

[Goonsquad]

I'll pretty much accept that as no significant difference, thank you Stevo, that puts off one reservation I was having about the switch.