CZ-858 Wont fire/Receiver cover Jammed.

[Robert22]

Howdy folks, wondering your advice in this situation.

What if a CZ-858 will not fire, and the receiver cover will not come off? Was this a result of poor re-assembly?

Thanks!

 

[Shadow_nt1]

the groove on the top is pretty small. Try and push forward and remove. The bolt should be free with it off. Then try and reassemble GENTLY. Then test bolt again. It should be the same.

 

[Robert22]

So, the receiver cover came off, and what appears to be the problem is the trigger is simply not engaging at all. Any news of this happening to anyone else? Is there a fix?

 

[mmattockx]

So, the receiver cover came off, and what appears to be the problem is the trigger is simply not engaging at all. Any news of this happening to anyone else? Is there a fix?

Dumb question, is the hammer cocked?


Mark

 

[Stevo]

So, the receiver cover came off, and what appears to be the problem is the trigger is simply not engaging at all. Any news of this happening to anyone else? Is there a fix?

You got the receiver cover off without de-cocking the striker?

 

[bfiles]

You got the receiver cover off without de-cocking the striker?

I would like to know this aswell??
The trigger doesnt engage but the rifle is cocked, so how the hell did the rear cover come off????

 

[Stevo]

I would like to know this aswell??
The trigger doesnt engage but the rifle is cocked, so how the hell did the rear cover come off????

With considerable effort and bent parts.

 

[Dr Evil]

Please read stickies.
There you will be shown by the administrator named Currton how to go about fixing the situation that you are in.

 

[Robert22]

Thanks for all the replies, stickies will be read.

 

[plinker 777]

Gremlin?

 

[bfiles]

With considerable effort and bent parts.

Has to be, i dont think there would be anyother way of removing the cover.