CZ Bren 2 - Handguards

D

Dan2

New member
Rating - 0%
0   0   0
Hello,

Does anyone have pictures of their Bren 2 with:

-11" factory barrel with muzzle brake and 13.8" HBI handguard
-18.6" N/R barrel with 10.8" HBI handguard

Trying to figure out what kind of handguard I should get, in hopes that we will be able to use our 11" Brens as N/R after the election. Hoping that the 10.8" on a 18.6" barrel doesn't look too stupid so that I can just use the same 10.8" when I put the 11" barrel back on.

Also thinking I could get the 13.8" in hopes that one day we can put the 11" and a suppressor on it. Will a suppressor/brake fit inside the 13.8" handguard?

Just trying to avoid buying both a 13.8"/15.8" and a 10.8" handguard later on
 
-11" factory barrel with muzzle brake and 13.8" HBI handguard
Click to expand...
Not sure you want muzzle blast within the handgaurd if the ports are covered by handguard. It is also a bit of safety because if you put hands too far out there is no warning. White light mounted behind ported muzzle devices also make sure it won't get covered up in soot and therefore less lumen. Plus if you run LAD not sure I want it right above muzzle blast and heat all the time.

This is mostly done with permanently attached suppressor. I personally do not think it is a good idea. YMMV
 
Dan2 said:
Hello,

Does anyone have pictures of their Bren 2 with:

-11" factory barrel with muzzle brake and 13.8" HBI handguard
-18.6" N/R barrel with 10.8" HBI handguard

Trying to figure out what kind of handguard I should get, in hopes that we will be able to use our 11" Brens as N/R after the election. Hoping that the 10.8" on a 18.6" barrel doesn't look too stupid so that I can just use the same 10.8" when I put the 11" barrel back on.

Also thinking I could get the 13.8" in hopes that one day we can put the 11" and a suppressor on it. Will a suppressor/brake fit inside the 13.8" handguard?

Just trying to avoid buying both a 13.8"/15.8" and a 10.8" handguard later on
Click to expand...
Brian46 said:
Click to expand...
10.8
 
You must log in or register to reply here.
Back
Top Bottom