I have both the new plastic bottom CZ 75 mags and the old metal mags. But I am wondering if I can put small rubber bumper pads on the metal mags. I know that the rule book states you can't adjust the magazines or change the overall length. But, if I put the rubber bumper pads on the metal mags, they match up to the overal length of the plastic ones. The pads are not weighted or anything, they will just simply protect my mags when I dump them on the ground. Is this allowed in Production Class? Or will my mags be banned from the matches?
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an alternative browser.
You should upgrade or use an alternative browser.
CZ mag bumper pads
- Thread starter CZ Man
- Start date
well, first off, you can not modify factory mags with non-factory parts, only aftermarket mags, which is where the guideline about not being longer than factory mags comes from. But fortunately CZ sells factory rubber basepads for the full metal body mags. and those are legal.
ipsc1 said:well, first off, you can not modify factory mags with non-factory parts, only aftermarket mags, which is where the guideline about not being longer than factory mags comes from. But fortunately CZ sells factory rubber basepads for the full metal body mags. and those are legal.
Ok great, so where do I get these baseplates in the Edmonton area? I haven't seen them on the CZ website. Did I just miss it ?
