CZ magwell adapter
- Thread starter TRich
- Start date
Funny you commented cause I was just looking at yours and I am considering doing the same thing hence the magwell adapter!
Does that include any mags ? Just trying to work out the final cost.
Ok, I've done some homework on this, as I have a csa vz58 in 7.62 with an adaptor, and it works great.
Czh-2003, cz-858 tac2, tac4, and older csa guns will require machining to accept the adaptor. If you remember, even the early .223 csa guns required machining. Later incarnations have the receivers changed to accept them. This includes some 7.62 models. I have one, and it works great with the latest csa adaptor. The earlier csa receivers, and earlier csa adaptors may not work without modifications. Basically, the changes to the milling of the .223 receivers was carried into the 7.62 guns, probably because it had no effect on stock guns anyway. Here is a pic of the proper adaptor, and gun with it:
Note the round mag release button, not the rectangular one. I don't know if that's significant, but I noticed it.
Czh-2003, cz-858 tac2, tac4, and older csa guns will require machining to accept the adaptor. If you remember, even the early .223 csa guns required machining. Later incarnations have the receivers changed to accept them. This includes some 7.62 models. I have one, and it works great with the latest csa adaptor. The earlier csa receivers, and earlier csa adaptors may not work without modifications. Basically, the changes to the milling of the .223 receivers was carried into the 7.62 guns, probably because it had no effect on stock guns anyway. Here is a pic of the proper adaptor, and gun with it:
Note the round mag release button, not the rectangular one. I don't know if that's significant, but I noticed it.
How much are the mags ?
$26.95 each at Wolverine.
the_klenzer
CGN Ultra frequent flyer
- Location
- Vancouver, BC
We should have a sticky about the various VZ58 models and magwell adapter compatibility.
