CZ452 Trigger Kit
- Thread starter 421
- Start date
trigger kit
421
I purchased 2 kits from Eric about 2 yrs ago. The kits consist of 5 different springs and 2 brass sleeves. The springs are all different strengths and the pins diff. thickness. My 22 cal 452 american had some creep as well as my american in 17HRM. My friend and I did 3 CZ in about an hour. His only required the spring. Mine needed the sleeves as well as the springs. Now both my CZs are set at 1 1/2 lbs with no creep. The pins change the angle to the sear and usually get rid of the creep. the springs give you a lighter trigger pull. As the kits are $15 US the price is right. I caution you doing the job only if you feel your qualified. If not buy the kit and take it to your gunsmith.---Cowboy
421
I purchased 2 kits from Eric about 2 yrs ago. The kits consist of 5 different springs and 2 brass sleeves. The springs are all different strengths and the pins diff. thickness. My 22 cal 452 american had some creep as well as my american in 17HRM. My friend and I did 3 CZ in about an hour. His only required the spring. Mine needed the sleeves as well as the springs. Now both my CZs are set at 1 1/2 lbs with no creep. The pins change the angle to the sear and usually get rid of the creep. the springs give you a lighter trigger pull. As the kits are $15 US the price is right. I caution you doing the job only if you feel your qualified. If not buy the kit and take it to your gunsmith.---Cowboy
skeetgunner
CGN Ultra frequent flyer
- Location
- Burlington
+1. I installed the Brook's kit, and was good to go. Since every CZ is just a little bit different, some experimentation is in order. But for $15us, it was worth the issue.
