Hi all, I've received my 12.5" Grizzly Barrel and is very excited!
However when I inspect the point where the barrel mates with the feedtube ring, I was surprised to see that the side of the contact has seams and not welded!
I want to know whether this may be a weak point;
1) Is the two parts welded only in the front and rear end?
2) Or is the whole contact surface(AKA Center) welded as well?
I run my shotgun very hard and I worry that repeatedly cycle the slide forward with force will eventually crack it(Namely, I abuse guns with hard cycling, don't we all love cycling our guns 100 times a day?
)
However when I inspect the point where the barrel mates with the feedtube ring, I was surprised to see that the side of the contact has seams and not welded!
I want to know whether this may be a weak point;
1) Is the two parts welded only in the front and rear end?
2) Or is the whole contact surface(AKA Center) welded as well?
I run my shotgun very hard and I worry that repeatedly cycle the slide forward with force will eventually crack it(Namely, I abuse guns with hard cycling, don't we all love cycling our guns 100 times a day?
)
