Danzig 71/84 mauser
- Thread starter Boguslaw Gwozdz
- Start date
There should be a round washer about the size of a dime fastened with a screw on the side of the bolt body. Unscrew the screw until it comes out about 4mm then stops. Don't try to crank it out too far, it is captive pinned so it won't come all the way out and get lost. Once the screw is backed out, the washer can be lifted to clear the receiver body as the bolt is pulled back. The selector lever needs to moved to half way between its two positions so that it pushes the flat spring out and doing so retracts a little knubby inside the boltway.
When you have done this, hold the trigger back and wiggle the bolt out.
Be careful, the bolt is assembled with some loose pieces which will fall off and drop on the floor, usualy rolling under the bench somewhere.....
When you have done this, hold the trigger back and wiggle the bolt out.
Be careful, the bolt is assembled with some loose pieces which will fall off and drop on the floor, usualy rolling under the bench somewhere.....
Last edited:
