deided to finaly build a AR mag for the tacticool 1022

[bone-collector]

What a pain in the @SS this was lol, but it fits perfect, now to sand it up and paint it, clean the JB Weld off the basset hound ..... and me and its done

all I used was:
-dremmel tool
-cutoff wheel
-grinder head
-1/8th drill bit
-exacto blade
-JB Weld
-Foam
-old colt AR mag
-old 1022 mag

-cut the top off the AR mag, notched the back out for the 1022 mag to fit snug, cut a peice of foam and pushed it in leaving about 1/8th inch from the top then drilled 6 holes in each side of the mag to use as anchor points

-drilled 3 holes in the bottom of the 1022 mag on each side then notched the back just a hair

-filled bottom of 1022 mag and holes with JB Weld and the top of the AR mag with JB Weld and the holes then clamped together

-YES theres runs and you can clean it as it runs, as the JB Weld hardens use a exacto blade to cut the runs away

 

[seanross]

sick ruger man

 

[bone-collector]

sick ruger man

thanks

 

[ozzy]

I did the same with airsoft mags. They were easy, just a little dremeling and some jb weld.

 

[Wham-O]

I'll take a dozen...

Nice job B-C!!

 

[ozzy]

very reliable too. great looking mag u made

 

[Jwirecom109]

Great design

 

[bone-collector]

I'll take a dozen...

Nice job B-C!!

Im not sure the basset hounds could handle that much JB Weld

and I should have a box of goodies from a good friend in the mail thismorning so will be a little buisy putting 2 more 1022s together today I hope

 

[Wham-O]

Im not sure the basset hounds could handle that much JB Weld

and I should have a box of goodies from a good friend in the mail thismorning so will be a little buisy putting 2 more 1022s together today I hope

About time it showed up!
Can't wait to see your new 10/22 builds.
Have fun...

 

[300Spartans]

Nice job, or as the young guys say nowadays, "sick, man!".

 

[bone-collector]

thanks guys