Dianna model 34 scatters shots

K

kenjohnson69

New member
Rating - 0%
0   0   0
Location
Alberta
I had a hunting rifle scope on my Dianna. It was deadly accurate to 30 yards. My kids managed to drop the gun and have the scope come off. I don't know if the screws were shaken loose. I remounted it. Can't sight it in. Never hits the same place twice. I put a air rifle scope on, same thing. What can I be missing? TIA
 
Are you using a new scope or the one that was dropped? I think your post says you are trying a different scope but getting the same result.

Is the scope mount damaged? Is the scope moving around? I'm surprised the scope came off- this would have to have damaged the mounts or the rails.

Is the barrel crown damaged?

Check all the screws and bolts- especially the forward screws that hold the powerplant to the stock and the hinge.

Is the issue unrelated to the drop? Is the barrel full of crud (have the kids been messing around)?

Lots of potential problem areas..
 
Pull your stock screws, clean, and put on thread lock tighten and leave for a day, typical as stock 34 have such a violent cycle to them. Use proper fitting screw drivers cause you need to tork them good. Even if this isn't the cause your gonna end up doing it, it's a 34 after all. Lock tight everything on those
 
They may have dry fired it causing the piston seal to be damaged, that could affect velocity shot to shot. Did the crown on the barrel get damaged? Are all the screws tight?
 
You must log in or register to reply here.
Back
Top Bottom