Did I really just get a 750 round case of LCW 9mm?

[drumstyx]

I've been checking the site every day lately, because the deals are too great. I saw the 750 rounds of LCW 9mm back in stock (by virtue of that awesome Glock combo...too bad I have enough 9mm's and not enough cash!) and of course just jumped on it. There was literally one in stock, and now that I've checked out, it's gone. Was this a technical glitch, or was I just super lucky?

 

[richmyster]

The stuff works decently. I think the lacquer on the round causes failures in my glock while the glock is still cold but once it warms up it functions fine. I say this because when I cleaned my glock after shooting this stuff there was lacquer all over the internals.

 

[drumstyx]

Yeah, I'm excited to get it if I really did happen to snag one case that they put up online recently. They've been sold out for a while, and Lugansk, Ukraine (of Lugansk Cartridge Works [LCW]) is of course in the middle of a war...

 

[EDF339]

Ordered mine last night too can't wait!!!

 

[drumstyx]

Ordered mine last night too can't wait!!!

Haha, this was the last thing I needed...I've spent so much this past week.

 

[Remote Six]

It runs great through my m&p, no problems at all

 

[Trevor Fletcher]

I snagged one this morning. I've put a case and a half through my glock17 since May with one ftf.

 

[richmyster]

Do you do rapid firing? High heat? Did you find lacquer all over your internals after firing off a couple hundred rounds?

 

[Trevor Fletcher]

I never noticed any lacquer on the internals. And I've done a reasonable amount of fast firing.

 

[Savage78]

I've been looking for them to get 22lr and .223 in stock and all there ammo is out of stock is there really this bad of an ammo shortage really CCI produces like 4,000,000 rounds of 22r a day how can there be a shortage the 4 million is a guess but still

 

[auracle]

I never noticed any lacquer on the internals. And I've done a reasonable amount of fast firing.

me too. and i inspect/clean after every trip. not questioning your experience richmyster. i think that its prudent to watch for that in any lacquered ammo. you dont need that stuff gumming up everything.

 

[CanAm]

Yes, we always hold back a few cases for warranty, testing etc. Once that is satisfied, we release the rest.

 

[maddogz]

Glad to here this stuff is good. Bought 2 cases of it hoping it works well in my Rhuzi. Very finicky firearm. Ran out of magtech 9mm FMJ(or was it TMJ?). Best 9mm I've ever used. Canadammo, can you get any magtech?? Haven't seen any in Canada for at least 7 years???