Dlask Arms XCR Stock Adapters **UPDATE**

Dlask Arms

Dlask Arms

CGN Ultra frequent flyer
Business Member
Rating - 100%
51   0   0
Location
Delta, BC
We have just finished a large run of our Robinson Armament XCR stock adapters. They are just out now for anodizing and should be back on the website by the end of this week. Sorry it took so long, we are just too busy to keep everything we make in stock all the time. The new adapters have a minor revision as well. A hole for a QD sling has been added, one on each side. (This was from requests we got to update the part.) Once they come back from coating they will be found here :

http://dlaskarms.com/products/xcrtm-m4-stock-adapter

*The picture will be updated once the parts are back in the shop.
 
We have sorted out a small problem that for some reason has not shown up until now. The issue is that the XCR-M version *can* have the firing pin protrude to far out the rear and will need hit the stock adapters when the bolt cycles. We took half of our stock and bored a .560" diameter hole through them to rectify this and it was confirmed with a customer that brought it to our attention. (You were very patient and informative in helping us address this, thank you Sir.)

So, bottom line, if you have the XCR-M with the rear protruding pin then you will need to wait a week until we can get the adapters re-anodized. If you have the XCR-L which does NOT have the rear protruding pin then you can once again find our stock adapters here :

https://dlaskarms.com/products/xcrtm-m4-stock-adapter
 
You must log in or register to reply here.
Back
Top Bottom