Dlask gsg 16 barrel

[Jamie]

Has anyone done there own barrel swap?

Cheers

 

[OkayShooter]

Check the GSG16 mod thread. Believe someone posted a YT video of what to do.. Bflies maybe was the one.

 

[Moe]

I did it. Took me about 45 minutes. Was not too challenging. Just take the time to do the extractor groove fitting right.

Cheers
Moe

 

[AntiKhaos]

https://www.youtube.com/watch?v=PjKA7QU5kWQ

Bwingpilot aka Motiuk Manufacturing posted a video of the swap.

 

[revilo]

I did mine following the youtube vid. My barrel already had an extractor cut and feed profiling. You need a vice grip and piece of rubber, a couple of wrenches, an allen key, and some loctite. Remember to loosen the lockscrew in the trunion, and the barrel turns off pretty easily. Screw the new one in until the barrel face is flush and the extractor cut lines up. Mine was a tiny bit proud of the trunion when screwed in but doesn't seem to affect operation at all. Take your time, go slow, and it's a pretty hard one to screw up, IMHO. Good luck!

 

[Jamie]

Just got to source a fixed rear stock and I am going to do this.