Does anyone make a die for...........

I don't think this is such a good idea! If your cases are not fitting, pull the bullets and resize them, do not put a loaded rnd into a loading die...it is now a chamber and where do you think the bullet is going to go exackly if the round goes off?

Scott
 
Does anyone make a die for fl sizing loaded cases?


If you are so inclined, you want a threaded body die. It sizes the shoulder and body and not the neck. Redding FL S sizing dies would work without the neck bushing. Check that the neck of the loaded round is not touched by the neck of the die. And use lube, you don't want to stick that one.

As said before, use caution. I might do a few if they are close to size, but if doing a lot and really having to move the brass, empty them and resize the brass only.

NormB
 
Thanks for the heads up but I can assure you I wasnt about to force a loaded round into a fl die. I thought I remembered hearing about a die specifically for this but i guess not.

I've got pile of .222rems here I've loaded. they were for a rifle I traded off and the rounds wont chamber in any other rifle I have.

Guess I need a puller.
 
Back
Top Bottom