Does Dominion Arms Grizzly barrel fit on rem 870 receiver?

S

SouthWest Guy

CGN Regular
Rating - 100%
122   0   0
Location
Leduc County ,AB
Want to have shorty 870 as bush gun, but can not find any short(10-12") remington barrel in town. Looks like Grizzly barrel from Canammo is only reasonable solution, any body ever try to fit Grizzly barrel on rem870 receiver?
 
And vice versa. Grizzly barrel/870 receiver and 870 barrel/grizz receiver was just a little tight going either way but both fit and function flawlessly.
 
They fit and function but from what Ive seen from 3 different barrels on 3 different receivers they don't index properly. I prefer the Chinese barrels on the Chinese guns.
Most people don't seem to notice based on the common responses here on CGN when the topic comes up.
 
Can-down said:
They fit and function but from what Ive seen from 3 different barrels on 3 different receivers they don't index properly. I prefer the Chinese barrels on the Chinese guns.
Most people don't seem to notice based on the common responses here on CGN when the topic comes up.
Click to expand...

Mine is spot on. Not that it really matters. (HP9 14" barrel on 870 Wingmaster)
 
2bad4u2 said:
Where you've recommended them, do you know if the barrels are still relatively thick? The Dlask barrels are good quality but end users have reported issues with forend clearance issues with these barrels.
Click to expand...

The NEA barrels were the thick ones.
Dlask is good to go.
 
ichbins said:
Mine is spot on. Not that it really matters. (HP9 14" barrel on 870 Wingmaster)
Click to expand...

You are correct, it doesn't seem to matter for most.

Mine all looked like this, this gun is resting flat on the milled flat part of the receiver and the barrel lug should be perpendicular to the table top.
 
Last edited:
You must log in or register to reply here.
Back
Top Bottom