Domestic HK 416 Clones

mildot

mildot

CGN Ultra frequent flyer
Rating - 100%
269   0   1
Location
Niagara
Any chance of these showing up here?
Here's some info from M4Carbine.net

So what's the story here? Are they assembling 416 uppers in the USA from HK parts, and adding a domestic SS nitride treated barrel?

Someone help me out here. I need to understand because this is confusing as hell.

They are apparently here in UT. I might have to pop into their shop and see what the deal is first hand.

Titan Defense TD-415 APS Gas Piston Upper
Modular Capability
The TD-415 drops onto your existing
AR-15/M-16 lower receiver.

10.50 Inch Barrel
- 416 Stainless Barrel
- RC 70 Corrison Resistant Nitride Finish

Gas Block
- Ambidextrous sling attachments
- Stainless with nitride finish.
- Low profile front site attachment
- Single Piece Piston Rod Assembly

Free Floating Quad Rail System
- interlocking one piece
- extruded 6061 aluminum
- freefloating rail

Upper Receiver
- Flat top mil-spec raised rail with key reinforcements

Bolt Group
- one piece bolt carrier
- nickel teflon finish for low maintenance

Spring and Buffer
- Tungsten high reliability buffer
- Stainless Steel

Caliber Available:
- 5.56mm X 45 (.223)
- other calibers will soon be available

td415upper10inch-4-2.jpg

td415uppers.jpg
 
twyeh said:
You can get the HK MR223
Click to expand...

I think your missing the point. Its a HK416 clone. Hence It can be used with all other milspec AR15 lowers unlike the MR223. Retail price of $1200 US, almost 4 times cheaper than what people are bidding on the Real deal ones, and if these aren't just cheap knock offs Im sure they'll be popular soon.
 
rambones said:
I think your missing the point. Its a HK416 clone. Hence It can be used with all other milspec AR15 lowers unlike the MR223. Retail price of $1200 US, almost 4 times cheaper than what people are bidding on the Real deal ones, and if these aren't just cheap knock offs Im sure they'll be popular soon.
Click to expand...
AFAIK the US-made HK MR556 will be compatible with standard AR lowers when it hits the market. The offset pins were a requirement of the German gov't for the German-made MR223.
 
There is lots of good piston conversion kits out now. I`ve been using a PWS carbine conversion and its been perfect.
 
eigenvector said:
AFAIK the US-made HK MR556 will be compatible with standard AR lowers when it hits the market. The offset pins were a requirement of the German gov't for the German-made MR223.
Click to expand...

Negative...Pins will be relocated. At least that's the word on the street over at HKpro.


***EDIT*** I was beat to the punch!!
 
I want that 100 rnd dual drum magazine!!!! Wouldn't THAT get you some LEO attention very, very quickly (even if it WAS pinned to 5 rnds and you only had it for looks :D)

Looks like it would be a great rifle to have. I wonder when/if we'd get the semi auto version and what it would cost.
 
Forgot to mention this in my earlier post.

If no, then are the only compatible mags from HK or are there after market ones available?
 
You must log in or register to reply here.
Back
Top Bottom