Dominion Arms 7.62x39 stick to magnet?

X

xopher

Regular
Location
Calgary
Before I make the plunge, I just want to make sure this ammo doesn't stick to magnets. My local range is anal about steels core and bimetal jackets (w/ steel).

Thanks in advance,

Chris
 
If your talking about shooting this at the TSE, it's not allowed unless the changed thier policy.
Even if it is lead core, they don't allow bimetal jackets.
 
xopher said:
Without a doubt it'll stick to the case. What about the bullet (projectile)?
Click to expand...

Bimetal jacket = copper & steal. So yes a magnet will stick. Its clearly on there website go look if you don't believe me. Most(if not all) eastern made ammo has steel in the jackets. If you need no steel you are most likely stuck with american made stuff.
 
Ya but it's allowed because the lead core is exposed, it doesn't damage their back stop. They sell it there to be shot at their range, trust me I did a little bit of digging before I spent 590 bucks on 1000 rounds
 
I've been pulling them all month for 303 reloads, they are bi-metal jacket lead core exposed flat bottoms. They measure out at .311 on the button and weights are majority 124.5 to 123.5 grains most closer to 124, powder measures over 30 rounds pulled were all the same to the tenth of a grain... if your wondering.
 
BCrecce said:
I've been pulling them all month for 303 reloads, they are bi-metal jacket lead core exposed flat bottoms. They measure out at .311 on the button and weights are majority 124.5 to 123.5 grains most closer to 124, powder measures over 30 rounds pulled were all the same to the tenth of a grain... if your wondering.
Click to expand...
Isn't it cheaper to use surplus? Or are you using the 303 indoors?
 
You must log in or register to reply here.
Back
Top Bottom