Dominon Arms Griz Mag Feed issues

natesfitness

natesfitness

Regular
Rating - 100%
67   0   0
Location
Petawawa
I just purchased a Grizzly-Mag from the EE and am pretty pumped to get it. Are there any issues I should be aware when feeding 2 3/4 shells that are common? I'm aware it doesn't handle 3inch so well.

Also I'm sure this question has been asked a bunch of times but can I put any 870 stock on it without fitting issues?
 
butt stock will fit no prob, but you will need to trim the fore stock slightly as well as do a little sanding of the interior to help it fit on the tube,
this of course pertains to if you are adding a wooden 870 stock
 
natesfitness said:
I just purchased a Grizzly-Mag from the EE and am pretty pumped to get it. Are there any issues I should be aware when feeding 2 3/4 shells that are common? I'm aware it doesn't handle 3inch so well.
Click to expand...


Don't short stoke it, the last shot wont chamber, and when you try to re-pump it the follower bolt stop with keep you from pumping.

3" shells will shoot, but there is not much room for it to move up the ramp.

I found that 3" will feed NO problem by chamfering the lower portion of the chamber only slightly, that and modding the mag to take 6 rounds and it removes the bolt hold open feature of the mags, so repumps are actually possible on the last shot if needed.

here is the thread.
 
The back stocks fit great and I have even put a surefire 618FA on one for a guy a few weeks ago and it fit great.

Good guns for the money however the fit and finish around the mag area tends to be a bit rough.

Gord.
 
You must log in or register to reply here.
Back
Top Bottom