Enfield No 4 Mk 1 Barrel Cut ?

[Loyer]

Is there any variation in the amount of barrel protruding from the from of theEnfield No 4 mk 1 ? What is the usual amount in mm or inches (ie: from the back of the bayonet lug to the tip of the barrel?
I am not sure if my barrel has been shortened or not.

 

[Tbolt]

Does it have the bayonet lug on it?
If so then from the back of the lug to the tip of the barrel you should have 2 and 5/8ths of an inch.

 

[JTF#]

do you have a pic?

 

[Loyer]

Does it have the bayonet lug on it?
If so then from the back of the lug to the tip of the barrel you should have 2 and 5/8ths of an inch.

Thank you Tbolt.

 

[samsplacci71]

I had asked the same thing a while ago. Turns out I picked up long Branch with the end of the barrel cut from the lugs forward.

 

[Loyer]

Just to be clear (for me) the end of the wood hand guard to the tip of the barrel is 2 5/8 " or 66.6 mm ?
There are two sets of lugs. I believe the lug near the tip of barrel is for bayonet while the lug set near the wood is for the sight. Could this be the confusing point?

 

[stevebc]

Just to be clear (for me) the end of the wood hand guard to the tip of the barrel is 2 5/8 " or 66.6 mm ?

Yes, that's correct: I just measured my No.4 Mk.2.