Extra long charging handle for a 10/22?

[.22LRGUY]

Hey guys-I decided to try one of those Etotech Rimfire units on a 10/22, and the base of the optic actually overhangs that wide receiver, at least 1/4" over the ejection port. I think you'd have to be careful the mounting screws didn't take a ribbon of skin off your knuckle even if the charging handle was 1" long. I think 1.25" long would be the minimum maybe?

Can anyone recommend something that long? Not a glitzy gun, so black/grey....cylindrical? Some of those hook shaped ones seem interesting, no experience with those...but don't see one as long as I need.

TIA!

 

[DANS40X]

Kidd-1-3/4" length
https://www.kiddinnovativedesign.com/KIDD-Bolt-Handle-Black-Ring_p_426.html

 

[99Solutions]

These stick out ten feet long:

https://www.brownells.com/gun-parts...-parts/1022-competition-bolt-handle-b1a54c6d/

I have one on a 10/22 and I actually can’t understand any of the complaints on the brownells site as it could be installed blindfolded like any other handle.

My only complaint about it is that I always found it to stick out the side of the 10/22 too far for my liking.

 

[Longstud]

Pike Arms make some nice ones but not sure if they’ll ship too Canada. A cut off centerfire casing epoxied over the original has been used before. The Dlask and Kidd are nice but only minimally longer than stock version.

 

[Wendell]

The bolt handle length is 1 3/4", which is 1/4" longer than the factory bolt handle giving greater clearance for the shooter's knuckles while racking the bolt.
<https: //www.kiddinnovativedesign.com/KIDD-Bolt-Handle-Black-Ring_p_426.html>

That's only US$138. per inch.

 

[m1008]

The factory 10/22 mag is a nice swap

 

[GimpyGolden]

Rimedge one from Tandemkross is decent. I think a few sponsor stores here have em.