Fab Defence Handgaurd wont quite close on the CZ858/VZ58

[CanadianBaconPancakes]

So it wont quite close. I heard your are not suppose to file the tabs?

Any Ideas?

I can get it almost completely in. Just a hair off!

 

[Bigbadpoppa]

Dremel?

Put it in the freezer overnight? It may shrink a hair enough to swap in. I do that with some of my motorcycle parts

 

[vince514]

these handguards need some fitting,use a dial caliper to mesure the total length you need.
try removing material with whatever tool you want to make it fit.

 

[bfiles]

Try tapping the bottom handgiard in with a rubber mallet. Should fit no prob

 

[CanadianBaconPancakes]

Try tapping the bottom handgiard in with a rubber mallet. Should fit no prob

I did this and Put Forward pressure on the top guard and it went into place finally. Super Tight fit but its solid with no wobble.

 

[Hitzy]

Bfh....