Favorite 10/22 mods?

GRiNGo

CGN Regular
Rating - 100%
74   0   0
Location
Meadow Lake, SK
Okay all you rednecks, I bought my first 10/22 on Friday. It is a standard blued/synthetic. I have new Bushnell 4-12x40 laying around to put on. So I want to know what are your favorite mods and all the info about them, you know how much, where to buy, how to do them....
 
well from the base model, all my 10/22's get the following

- Volq. Match Hammer and Sear
- Volq. Auto Bolt Release
- Volq. Extended Mag Release
- Volq. Exact Edge Extractor
- Bolt Buffer

then from there, it is usualy a skeeter full width trigger and the bull barrel of yur choice in a stock of your choice.
 
Last edited:
Ya, about what he said :D:D

Most important is to fine tune the whole trigger group, either a whole drop in set, complete replacement, or send the stco group to a good gunsmith(Unless you can do it all yourself!!)

Bull barrel is also nice, and so is a decent stock....

I also have a bolt buffer, and makes the gun quite a bit quieter!

Extended mag release is also a nice add on!

Heres a piccy :D

P6151755.jpg
 
what i did

Asside from all the VQ internals I added a set of kwik sight receiver mounted
see through mounts and updated those poor sights to a set of willams fire sights. Mind you if this is done the largest scope i could use was a 32mm.
 
Last edited:
Back
Top Bottom