Favour - Kimber 8400WSM stock dimensions

[Mik123]

I'm hoping someone with a Kimber Montana in a 8400WSM action can give me the measurements below:


- Inside length of the magazine
- Middle of the rear screw to the back edge of the magazine well

-Middle of rear stock screw to middle of front stock screw

-What is stamped at the bottom of the magazine well (for example the 8400 magnum has LA8400#3)


Thanks!

 

[pete dobinson]

Inside length of mag well - 3.170 Middle of rear screw to back edge of mag well - 2.716 Middle of rear stock screw to middle of front stock screw - 6.661 No stamp at the bottom of the mag.

 

[pete dobinson]

With the steel magazine liner in the mag well the length is 3.025. These measurements are as close as I could get with my callipers. The screw holes I measured from the stock holes, not the action holes.

 

[Mik123]

Thanks, I appreciate it. It's all the info I need.

With the steel magazine liner in the mag well the length is 3.025. These measurements are as close as I could get with my callipers. The screw holes I measured from the stock holes, not the action holes.