Flip cover on a SPARC

DocBurN

DocBurN

Regular
EE Expired
Rating - 100%
15   0   0
Location
Montreal, Canada
I was wondering if it was possible to add a flip cover on the vortex sparc, kind of like his big brother strikefire..

Any of you seen an aftermarket optic flip covers that would fit the Sparc ?

Thank you very much!
 
Yes!!!! I have a set on mine.... Butler Creek #4 front and rear

MP15-22.jpg
 
Timbertec said:
Yes!!!! I have a set on mine.... Butler Creek #4 front and rear

MP15-22.jpg
Click to expand...

1 last question..

is it 2x Butler Creek Flip-Up Rifle Scope Cover #4 Objective (Front)
or
did you use one #4 Objective (Front) + the Butler Creek Flip-Up Rifle Scope Cover #3 Eyepiece (Rear)

the rear seem to have a red switch
490672.jpg
 
I can confirm the #4 Objectives work perfect for the Front and Rear. Forms a nice tight fit.

I would be hesitant about the recommended EyePiece (Red Button) #3 referenced above. The diameter of the Sparc on both sides is essentially the same. The #4 objective which works perfectly is 27.8mm. But the #3 Eye Piece is 35.3mm which is a significant 8mm difference (almost a whole centimeter). Even the #3A is too big at 33mm. The smallest eyepiece version with the red button is the #02 which is 31.1mm which I believe is too big for the Sparc without modification.
 
very helpful guys! I was hesitating between the strikefire and sparc.. the only info i got come from CGN, but if im not mistaken, the 2 moa versus 4 moa is enough to pay a lil extra for a sparc. hope i made the right decision.

I'll try to find a Canadian seller that carry the 2x Butler Creek Flip-Up Rifle Scope Cover #4 Objective (Front)
 
You must log in or register to reply here.
Back
Top Bottom