Fobus Holster Safety Issue

Yep I like raven products. Well built, configurable products. Good communications from the factory.

Even though it's more or less a custom order scenario I had a fast enough turn around from them (4 weeks).
 
If the gun is all the way in, it's the wrong holster.
You can see where the front of the trigger guard should be and also the trigger,You are at least 1/2 an inch too far out.
Try loosening the screws under the trigger guard (if they are screws and not Rivets) or better yet, buy a Bladetech.

I bought the Fobus for my 92A1 as I'm not into leather and at the time Bladetech didn't seem to have one to accommodate the rail (and may still not, I haven't checked). Trigger is only barely visible when hammer is back. Not enough to snag, but you never know.

it does sit deep in the holster though...

IMG_1591_resize.jpg
 
My P226 in a Fobus. Part of the trigger guard exposed.

IMG-20111115-00121.jpg


P226 in my Blackhawk Serpa. No trigger guard exposed.

IMG-20111115-00123.jpg


I'll use the Fobus on days when I'm just plinking, but I really prefer the Blackhawk.
 
I don't mind the Fobus I picked up for my Makarov. Then again it's my only experience with them and I only bought it because it was cheap. If I had competition or CCW in mind I would try hard to find something better.
 
Back
Top Bottom