For 338 Cannon Lovers

[Mystic Precision]

For those looking for serious LR horsepower, you might find these wildcat of interest.

300gr MK 3400+fps.

Makes that Lapua look kind of girlie

Enjoy...
Jerry

http://www.viersco.com/

http://www.viersco.com/

 

[danny1444]

###

 

[dan belisle]

Well, it does look cool, but you're back to difficult to get (to impossible to get) brass again. 505 Gibbs brass just isn't that common. Nice ballistics though. - dan

 

[Mystic Precision]

Gibbs brass IS difficult to get but Chey Tac/Rigby brass isn't.

Just expensive.

I estimated cost per bang at $1.50 due to our extremely strong dollar. Way cheaper then a 50BMG and about as useful.

You would definitely want an oversized/strong action so a full meal deal custom job. Again, cheaper then a BMG but not by much. Then there are custom dies and the bullets/powder by the keg.

For those who want to hunt at extreme range or break rocks at 4 digit distances or just have a big a$$ bruiser, these are the cannons.

Unless you actually get a BMG

Jerry

 

[tac-driver]

How accurate is it at 1600 yards, I wonder?

 

[Mystic Precision]

There is no reason to doubt MOA or better at all ranges.

As long as the 300grMK can survive the initial launch, it stays accurate until it hits something.

Many are using this bullet for extreme range hunting at slightly lower velocities. At the distances used, the bullet has gone subsonic but still retained accuracy.

Going faster just means it will go that much further before it goes subsonic.

Lots of options in the 3000 to 3200fps range. This monster just pushes the bullet to its mechanical limit. I doubt the MK will tolerate going much faster then 3500fps.

Jerry