Gevarm E1
- Thread starter Cus-Cus
- Start date
JohnC
CGN Ultra frequent flyer
as I recall-
remove the barrel pull the trigger or vice versa. & let the bolt go forward. then move the little lever underneath back - ( i think - it's been awhile) this will let the bolt go all the way forward to where the bolt handle slot is wider & you can then pull the bolt handle out, BE VERY CAREFUL to control the bolt by blocking with your hand at the front while you do this-it will go flying with TV screen breaking force because of the spring if not controlled . Reassembly is reverse.
There is a movable plug- sping guide. If you put it at the end of the spring away from the bolt the gun will cycle faster because of reduced bolt mass ( or cycle weaker ammo); if you inset it inside the bolt (other end of the spring you will bget slower cycling which is better for hot ammo.
Send me a PM with your email address & I can send you pics of a user's manual- bad copy because of flash picture refelctions, but still useful) in a day or two
remove the barrel pull the trigger or vice versa. & let the bolt go forward. then move the little lever underneath back - ( i think - it's been awhile) this will let the bolt go all the way forward to where the bolt handle slot is wider & you can then pull the bolt handle out, BE VERY CAREFUL to control the bolt by blocking with your hand at the front while you do this-it will go flying with TV screen breaking force because of the spring if not controlled . Reassembly is reverse.
There is a movable plug- sping guide. If you put it at the end of the spring away from the bolt the gun will cycle faster because of reduced bolt mass ( or cycle weaker ammo); if you inset it inside the bolt (other end of the spring you will bget slower cycling which is better for hot ammo.
Send me a PM with your email address & I can send you pics of a user's manual- bad copy because of flash picture refelctions, but still useful) in a day or two
