Glock 10 mm FTF problems

4

41 Mag

New member
Rating - 0%
0   0   0
If I pull straight back on the trigger, you hear the firing pin release but the cartridge fails to fire, but on inspection it has been hit by the firing pin. If I apply slight pressure to the left as I squeese the trigger then there is no problem. the cartridge fires each time. I have cleaned this firearm thoroughly, I've lubricated properly but back on the range the next time I encounter the same problem. If you take the bullet that failed to fire and put it back in the clip and apply pressure to the trigger from the side, it will fire. Does anyone have any idea why this is happening and what ideas for correction. Thanks
 
Have u done any changes like a lighter connector and striker spring? Is this on factory loads or are you using reloads? Just curious due to the difference in primer hardness...:confused:
Hopefully it will be figured out in this forum.
Cheers
dB:)
 
You must log in or register to reply here.
Back
Top Bottom