Grizzly 3 or 4 3" shells ?

If you replace the high visibility follower with a remington metal or plastic follower you MAY gain enough to get that extra round in. I repeat MAY. edit: I disassembled my mag to see if I could get anymore in it , the mag follower is basically the same as Remington's only bright. Unfortunately what you have, is what you got. You could get an 18 1/2in barrel and a mag extension or use 2 3/4in magnum shells but you can't get anymore 3in. in the gun.
 
Last edited:
whats a downside of cutting the spring shorter, its strong enough tp push them out without 2-3-4 coil anyways i think. or is the follower hitting the end cap and the spring fits inside them ? then i can trim the end cap to be shorter too right ?
 
Same problem here... norinco hp9-1 (basically the same gun except the hp9 is parkerized, not black oxide)... I agree though it looks as though an extra 3/8" would fit the last 3" shell...

too bad though :(
 
DragonFire said:
OK, maybe a stupid question but is it possible to add a one shot mag extention on the Grizzly or would than even extend past the barrel?

DF:D
Click to expand...


i dont think 1 shot extensions exist? anything more would go way past the end of the barrel...
 
###XX said:
i dont think 1 shot extensions exist? anything more would go way past the end of the barrel...
Click to expand...

Of course 1 shot extensions exist, they're practically the most common, it's at the top of the pic, and adds about 7/8" to the length of the mag tube for those curious. No idea how it would look on a Grizzly.

P1060435.jpg
 
Im pretty sure I got 4 Winchester Xpert 3" shells with BB shot in them inside my magazine. Last one didn't want to go in, but I just gave it a good push and it popped in and cycled fine.

EDIT: Okay, I just tried to confirm this statement and it is not true. I cannot fit 4 3" shells into my grizzly either.
 
Last edited:
You must log in or register to reply here.
Back
Top Bottom