Guide Lug/Oprod/M1

C

Clancy

Regular
Rating - 0%
0   0   0
Location
N. Catasauqua, Pa.
Gentlemen,
THIS IS IMPORTANT!!!

Here's another photo, which is very hard to see because it is off very old microfilm. However, you should be able to "see" my point. The photo shows the Guide Lug area of the oprod. Number 1 shows us that it was not hardened and you can "see" the area is cut. It states the following for number 1. The unhardened number one FAILED at about 2700 rounds. Number 2, which was hardened at the Guide Lug by Induction Hardening, was ok after 12,000 rounds. This testing was done in 1944 and 1945. You guys just have to get my books.

oprod2ah.jpg


http://www.garandm1rifle.com
http://www.users.fast.net/~eclancy

Thanks again
Clancy
 
I don't think is the right forum to flog your books - no offense inended, but the exchange forum may be better suited if you're selling somthing.
 
naugler,
I understand your point. I had check to do it and they said ok. However, many can't see the free data and info I have on the sites and my posts. I will do as you ask and not post anymore of this type data on this site.
Thanks for your comeback.
Clancy
 
You must log in or register to reply here.
Back
Top Bottom