Has anyone put a scope on a PC9?

M

MisterJ

CGN Regular
Rating - 100%
9   0   0
Location
Etobicoke
Hey all

I'm setting up my PC9 and I have a Vortex Crossfire that I'm going to put on it. I also bought three Pmags so I'll be swapping out the magwell probably this evening. My question is, have any of you put a scope on it instead of a red dot?

Also what distance do you zero it for? I'll do it for 50m because that is the shorter distance at the range I'm a member of. I am curious if anyone zeroes it out to 100m (or yards).
 
Yes. A 1-6x with .223 BDC.

I use a 50m zero. Beyond 150m it's a crap shoot with the football-like ballistics of the 9mm. I only did it for 3 gun because my eyes are crap and the BDC is useful for holdover reference on shots out to 200m.

Out to 100m a red dot is more than fine if you can see the target.
 
2-7x35
Chronoed my load and ran it through the ballistics calculator
Near zero at 20 m, far zero at 75, iirc, and it stays within 7-10 cm vertical corridor out to 110 m or so
Good enough for run and gun
 
Has anyone found a see-through mount that allows you to still use the irons? I've tried every one in my safe and the see-through channel is too high on all of them.
 
jacotsmith said:
Has anyone found a see-through mount that allows you to still use the irons? I've tried every one in my safe and the see-through channel is too high on all of them.
Click to expand...

jonas on my pcc in 9mm im using the same kind of mount as for the ar15 i found it the easy to remove if needed. im talking about the burris qd pepr ... it is a little higher for the cheek but still able to shoot it for what im doing.
 
Put a fixed 4 x 32 x 8" long on both my PC9 and 10/22. Had no issues with either scope.
Scopes fit nicely in the cases and both are zeroed @ 50 yrds.

Ec1ahwc.jpg


rF9rJum.jpg
 
I tried mine with an ugly red dot, but I use a 10/22TD pack, so took it off. So far, I’ve ever only used it for plinking. Like the rifle very much.
 
You must log in or register to reply here.
Back
Top Bottom