Hatsan MPA Front Sight Upgrade

M

MexicanForklift

Member
Rating - 0%
0   0   0
Anyone know of an upgrade out there for the front sight on a Hatsan Escort MPA? I don't like how it looks, and the red fibre optic piece is too small and not visible.

I want to to remove the rear ghost ring, put a red dot on it, and have a nice bright (tritium?) front sight for a back up. If there's nothing out there, I'll just remove it and put a bit of paint on the nub that's left.
 
The same way you use a bead, except its elevated a bit off the barrel so you can see it while looking down the rail. Seems like a good backup sight to me.
 
The sight on a hatsan is about an inch above the barrel. The rail is 3/8 at the most above te barrel. You'll be shooting feet low at 10 yards?? Why not leave the ghost rings as a backup?
 
Oh so you want to put a bead on it. Makes more sense. I would suggest a taller than average bead to make up for the height of the rail. And yes I have had an mpa for over a year now. Love the sights. Was tagging a 6x6 steel plate at 50+ yards the other weekend. Reapetedly using the stock sights

Regarding your comment on nonsense. The only nonsense I see here is putting a red dot on a shotgun.
But that's just an opinion.
 
Last edited:
@ Dieseldawg I'm glad you like the sights it came with. Thanks for posting, despite adding nothing to the thread.

@ EL34/6L6 I think you mean on the rear sight? If so, then yes. I wouldn't want to alter it past the point of being able to return it to original config, so I'd just unscrew the ghost ring and save it.
 
You must log in or register to reply here.
Back
Top Bottom