heeeeeelllllpppppp fab defense butt stock removal

pizdets17

pizdets17

CGN Ultra frequent flyer
Rating - 100%
112   0   0
Location
Calgary
Im stuck!! I removed the back of the stock but the tube thats screwed into the gun is still there, how do I remove it?/ Anu advice would be helpfull, I know its an allan key but nothing ive tried fits and the gun came with this stock when I bought it on EE
 
I just measured my Allen key with a really cheap Vernier caliper. 3.8mm (therefore 4mm) Allen key and it needs to be 5 - 5/8" in length. The end of the Allen key is rounded to allow it to work at an angle. You will have to turn this Allen key bolt out to remove the mount and tube with out destroying the Fab mount. There is a small hole in the plastic under the tube that the Allen key fits into but you will need the total length to reach the bolt. Good Luck.
 
just tried with a 5.5" 4mm key twisting and turning and all kinds of bending (including bending the key with pliers to "round it out) and no luck, Bout ready to get a hammer :mad:
 
PM me with your email address and I will send you a photo of the tool. I am sure these are availiable at Candian tire. If not, I am in Calgary at the gun show next weekend and I could bring my wrench along for you to give a try.
 
You must log in or register to reply here.
Back
Top Bottom