HK lighter LEM strigger spring?

M

meterus

Member
Hi,

Can you get the 4 lbs HK LEM trigger spring? The 8 lbs HK45 LEM is just tooooooo heavy. When I shot, bullets were spilling all over the place.
 
Let me check into this, I had done so already about a year ago or even longer and at that time was told that this was for Law Enforcement retrofit only.
Will advise.
Wolfgang.
 
These are available.
If interested, drop us an e-mail.
Trigger return spring HK part # 209266 (black colored, thinner trigger return spring) for light LEM trigger pull, approximately 4-5 lbs.)
Cheers,
Wolfgang.
 
Wolfverine said:
These are available.
If interested, drop us an e-mail.
Trigger return spring HK part # 209266 (black colored, thinner trigger return spring) for light LEM trigger pull, approximately 4-5 lbs.)
Cheers,
Wolfgang.
Click to expand...

Light firing pin block spring is also in order if doing the light trigger spring. For the DIY crowd, the installation tool would help :)
 
I was also told that I need the light trigger return spring AND a light firing pin block spring to convert the LEM trigger. FPBS HK part # 209296. Can you please confirm with HK if we need this spring too? Thanks!
 
meterus said:
I was also told that I need the light trigger return spring AND a light firing pin block spring to convert the LEM trigger. FPBS HK part # 209296. Can you please confirm with HK if we need this spring too? Thanks!
Click to expand...
According to HKpro in US, you in order to convert HK45c from LEM to LEM light you will need the aforementioned trigger return spring 209266, your existing firing pin block spring 209296 and a lighter hammer spring 234479.
Link (remove 3 spaces) to spring guide chart http://www .hkpro.com/forum/hk-reference-library/168700-spring-reference-chart-different-lem-variants.html
I don't know if this is indeed fact, however the people on this site appear to know a whole crapload about HK firearms.
 
mr.fatstacks said:
According to HKpro in US, you in order to convert HK45c from LEM to LEM light you will need the aforementioned trigger return spring 209266, your existing firing pin block spring 209296 and a lighter hammer spring 234479.
Link (remove 3 spaces) to spring guide chart http://www .hkpro.com/forum/hk-reference-library/168700-spring-reference-chart-different-lem-variants.html
I don't know if this is indeed fact, however the people on this site appear to know a whole crapload about HK firearms.
Click to expand...

Thanks for sharing. Looks like we already have the FPBS 209296 installed, and we just need to have TRS 209266 and HS 215694 for a light LEM.
 
I know it's possible to convert the DA/SA to LEM 4LBS. Can we get the detent plates and any other pertaining part numbers (unsure of the part #s) for that conversion?
Thanks
 
You must log in or register to reply here.
Back
Top Bottom