Holster for small frame revolver?

[manbearpig]

Hi folks.
Can someone recommend a belt holster (w/source) for a small 9mm Rohm signal launcher? I am guessing it might be the same size as a 'small frame' revolver, but I have absolutely no experience with revolvers so i have no clue.

I keep one up north at the cottage in addition to a can of pepper spray w/holster for those people who do NOT have their PAL and like to go wandering off in the bush. Something with a small pocket i could fit a 15mm bear-banger and flare into would be even more ideal.

the pistol looks like this:

and is 155mm in total length.
thanks!

(i cant take a scale pic right now because i left it up at the cottage)

 

[RePete]

Try to compare it with a 2 - 2 1/2" K-Frame revolver, and if they are the same then get a holster to fit the K-Frame.

 

[manbearpig]

thanks,
i dont know anyone who has one - hell noone i know even has a revolver. all my friends have 1911s, Glocks, Walther P99s, etc.

i will dig around on some backup discs and see if i can find some old photos i took of it - i think one had a toonie beside it for scale. it will be another 2 weeks at least till i can get up to the cottage again so i cant take any new ones until then.

 

[manbearpig]

this is all i could find of old pics. its 6.1 inches long.
theres a pic with the cylinder open, it takes 9mm blanks so you can judge how large the cylinder is.

 

[7.62mm]

Hows about something like this from Marstar, seems to fit your requirements:

UTG Multi-function Concealment Waist Pack

http://www.marstar.ca/main/new-arrivals.shtm

Almost to the bottom of the page.

 

[sunray]

"...for those people who do NOT have their PAL and like to go wandering off in the bush..." That'll gain them nothing but unwanted attention from any CO who wanders by. Just because it look like a real revolver.

 

[manbearpig]

i am not worried - we are responsible folk and it is being carried (with blanks, bear bangers and signal flares) on a belt with a can of bear spray and a bear bell. it would be a different story if they were running around downtown Toronto with it, but theyre not -- i have faith that COs arent completely insane and unreasonable.

 

[Boomer]

I would go with an inexpensive Uncle Mike's nylon belt holster. You could also try to find a nylon .410 shotshell slide so you have fast access to the cracker shells in. The .380 blanks are a bit of a nuisance, but a snap down shirt pocket makes as good a carrying pouch as well as anything else.

Edited to add . . .
The holster will have to be long enough to accommodate the gun with the launcher adapter screwed into the barrel.

 

[manbearpig]

thanks boomer, i will check it out.