I saw a post somewhere where someone made something like this so I thought I would give it a shot. I cut some scrap metal I had to approx 3/4" x 1.75" (can't remember exactly) and then drilled a hole in it and ground down the upper portion of it.
I put the end with the hole in a bench vice and gave the paddle part a 90% twist.
I bought a few lag bolts, washers and some kind of brass spacer type thing (probably for air or hydraulic hoses, steel or aluminum tubing would also work).
Grabbed a small ratchet and screwed it into a pole out back.
It works pretty good. I was 10 for 10 shots at 30 yards supported, which is minute of magpie in my book. On a side note, I haven's seen any difference so far with the POI between the JSB Hades and the JSB 15.89gr pellets.
I put the end with the hole in a bench vice and gave the paddle part a 90% twist.
I bought a few lag bolts, washers and some kind of brass spacer type thing (probably for air or hydraulic hoses, steel or aluminum tubing would also work).
Grabbed a small ratchet and screwed it into a pole out back.
It works pretty good. I was 10 for 10 shots at 30 yards supported, which is minute of magpie in my book. On a side note, I haven's seen any difference so far with the POI between the JSB Hades and the JSB 15.89gr pellets.
