You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an alternative browser.
You should upgrade or use an alternative browser.
Hornady 6.5mm CX 130 gr
- Thread starter coleur
- Start date
I just ran the top two 5 rnd loads through a6.5 PRC using Hornady recommended data for H1000.Somebody have reloading experience with this bullet? How many jump have you try for precision?
Groups were around 2 MOA Or sure if I’m going to continue on with this bullet
Hornady data calls for 2.920 COALSomebody have reloading experience with this bullet? How many jump have you try for precision?
That’s a 80 thou jump in my Bergara which measures 3.003 OAL
And 2.403 from Ogive.
I may try them again with 20 though off the lands , using the Ogive measurements.
I’ll let you know if it makes any difference
So I tried them again today 30 thou off the lands.Hornady data calls for 2.920 COAL
That’s a 80 thou jump in my Bergara which measures 3.003 OAL
And 2.403 from Ogive.
I may try them again with 20 though off the lands , using the Ogive measurements.
I’ll let you know if it makes any difference
Hornady book COAL ,which was 80 thou jump,was 2.5 MOA
Tried same load with 30 thou off the lands and improved to 1.5 MOA.
I don’t think my barrel likes 130 CX
Thanks for the follow-up. Do you have same result with Barnes?So I tried them again today 30 thou off the lands.
Hornady book COAL ,which was 80 thou jump,was 2.5 MOA
Tried same load with 30 thou off the lands and improved to 1.5 MOA.
I don’t think my barrel likes 130 CX
Haven’t tried BarnesThanks for the follow-up. Do you have same result with Barnes?
