Hornady loc n load case prep

[schoots]

Just trying to do some research on this . Is the case trimmer accurate ? I hear there is slop in the set up .
Do you like it ?

Thanks

 

[New Camper]

I have the case trimmer and neck turner (same cast base) and am satisfied with the results. I assume the "slop" you heard about is the alignment? I doubt it's a problem with machining but the brass: Ultimately I would yield to a qualified machinist testing, and opining Hornady's tolerances. Assuming it's run out in the brass, the pilots of both hold the neck consistently centered in reference to their respective cutters.

 

[schoots]

Thank you