Hornady Match Brass

[yukoncoyote]

Prepped up some Hornady brass in .308. I can't seem to push in the primers without much effort. Scared to get one stuck in the primer tool. I'm using a Lee priming tool. Primers are Fed 210's. Anyone had this problem before?

 

[Spyderfire1]

I'm using the Hornady Brass in 300wm and my RCBS tool will not push them in either. I think its a combo between tight primer pockets and a bad tool design. When I use my press to push them in they go straight and with only a little tension. Again, I thinks its the priming tool problem, RCBS aparantly makes a better unit that mounts on a bench but i found that using my press is simpler.

 

[yukoncoyote]

Tried it on the press. There is no way a large rifle primer is going into the pockets without some sort of reaming. Gonna use some brass that I know will work and scrap the Hornady. Not impressed really.