How is Privi Partisan brass for reloading?

I have found the Privi brass to be good. Use it in 7.62 x 54R, mostly neck sized, 5 & 6 loadings so far, no issues. I have used the Winchester in the same cartridge, and found it to be good too. Strangely enough the Winchester brass was primed when I bought it and required the primer crimp removed on reloading. I have purchased some 6.5x55 Privi cases but have yet to try them.
 
I had some for my 7x57 Mauser. In my experience, the case rim was too thick to fit in the shell holder on many. Of the 20 I had, only 12 would slide into the shell holder for decapping and priming. I tried my RCBS and Lee shell holders and they just would not slide in.
 
I'm currently loading 7.62x39 with it and it's holding up fine. Case length is quite a bit shorter than maximum, but I'm not complaining.
 
Ppu45autoG.jpg
 
I have not shot it personally but have sold a bunch in various chamberings. Very nice looking stuff.

PRVI is one of the worlds largest supplier of military ammo, now greatly expanding into civi stuff. Think WOLF ammo.

They make all their brass in house and their stuff looks really well made. Annealing appearance is similar to what you see on Lapua brass.

All brass that I have seen is stamped PRVI then chambering just like any other US manf.

Jerry
 
When I was resizing my brass I could always pick out the Prvi brass. It is noticeabley harder to size. Nothing bad, just noticable. That said, it was good stuff and worked as well as Win, Rem and Federal.
 
You must log in or register to reply here.
Back
Top Bottom