from SKS optic sticky
7. REMOVAL OF REAR SIGHT LEAF.
1. if you have a pin in your leaf, remove it first, you can see it from the side where it pivots.
2. pic below: using electrician tape , tape over the leaf a few times to protect the finish.
3.pic above right: then using a 2" clamp tighten gently , do not over tighten, watch for the movement from the top.
4. below pic: after it moved down 2mm , insert a straight edge screw driver.
5. above pic right: tilt the screw driver forward, if the leaf doesn't move then tight a wee bit more.
6. below pic: when re-inserting the leaf , make sure the part that slides clears the rear hump (see pen) of the sight base. NOTE, this is important or you could be hammering all day and it wont move. tape it again.
7. above pic right: tighten clamp, using a mallet gently tap in the leaf.
[/SIZE]