How to fix co2 mag leakage

[556223]

Hi, My new Springfield M1 mag start leaking this weekend, no matter how tight I screw it down, I can still hear air comes out from the bottom of the mag.
Does anyone have same issue? how to fix it?
Thanks in advance!

 

[guntech]

I am not familiar with the M1 but often screwing down too hard on a seal damages the seal and it will need to be replaced.

 

[gunsaholic]

The seal is likely buggered now. Some say you can put a small piece of teflon tape on the end of the CO2 cylinder but that's a bandaid fix.

 

[Foxer2373]

Oil your o rings, if that doesn’t do it, replace the o rings... that is always step one with a gas leak.

 

[556223]

the mag looks like this one, very hard to replace the seal.
https://www.dropbox.com/s/iro205muuobykwe/IMG_0865.jpg?dl=0

 

[556223]

I have to put 3 layers of telfon tape now to stop the leak lol. sick'n tire of it.

 

[gunsaholic]

the mag looks like this one, very hard to replace the seal.
https://www.dropbox.com/s/iro205muuobykwe/IMG_0865.jpg?dl=0

That's cause they want you to buy the whole mag. I have one of those Mauser broom handle air pistols that is the same way.

 

[motoman]

I was reading an air gun article they have used a bit for transmission stop leak fluid on the seal to swell it