How tough is powder coating?

[Auggie Doggie]

So, just how durable is powder coating.? I recovered this copper plated bullet from the berm.

It had been impacted by one of my 130gr. RNFP .357 light loads I had powder coated with Traffic Red. Looks like the PC has stood up very well. I'd say PC is plenty tough.

Auggie D.

 

[lpel]

Very nice and similar to the results I’ve been getting. That’s a nice thick coating you’ve got on there! Is that pure WW?

 

[SKS50]

A recovered 45 ACP HP I cast from 50/50 I shot out of my Hi Point carbine.

As you can see the coating on the Yellow/Green bullets is not heavy at all.

 

[Auggie Doggie]

Very nice and similar to the results I’ve been getting. That’s a nice thick coating you’ve got on there! Is that pure WW?

Yes, one coat of PC on air cooled WW.

Auggie D.

 

[hatman1793]

Ohhhhh...... those new pc bullets are nice....
Whose mold is that?

 

[SKS50]

Ohhhhh...... those new pc bullets are nice....
Whose mold is that?

I take it your probably asking me the question so here is the link to the mold. Haven't cast any of the flat point bullets yet but have cast plenty of the cup points pictured and the hollow points below.

http://noebulletmolds.com/NV/produc...cts_id=3281&osCsid=fblsovu011ole00hansfm3dlo1

 

[hatman1793]

Can i borrow it?

 

[snuggy1955]

Ive seen this. And otber videos on youtube... Has anyone compared powder PC to copper plating lead bullets? Or not a viable option?