Husqvarna 5000 advice

[fire@will]

Good day, gentlemen.
Not sure if this is the right section for this - it ain't exactly "smithing", but I figured that here is where the most concentrated knowledge would be.
I have a bolt action Husqvarna, H5000 - in 30-06. There was the tiniest bit if rust on the crown of the muzzle and after taking care of that, I started wondering if there might be more, hidden under the stock - so I decided to have a look. I have removed the two bolts, from just forward of the magazine and behind the trigger guard. I can't see anything else, holding it together - but I can't seem to separate the barrel, or the trigger assembly from the stock.
Is there something I'm missing, or not doing correctly ? Your help is greatly appreciated.

 

[freire]

The rifle has probably been bedded, slowly with steady pressure try to pull it apart.

 

[fire@will]

Thank you for that, freire - I've tried that and it doesn't seem to be working. I am pulling - but it doesn't want to separate. The trigger assembly is aluminum and I don't want to break it. The barrel is just as stubborn.

 

[chappy]

put it in the freezer for a few hours then hold the stock and rap the barrel with a rubber mallet. bedded or not it should come apart.

 

[fire@will]

Thanks, chappy - I'll try that.

 

[kamlooky]

Wasn't there a hidden screw on one of them?

 

[fire@will]

That ! Is my concern.

 

[freddygotarf]

No hidden screws. Your thinking of parker hale with detachable magazine.

 

[fire@will]

Just a quick update. After receiving some advice from "Baribal" - I got it apart. Just needed a bit more persuading, than I was originally comfortable doing. Thank you all for your help.